Oracle EXADATA X6-2, Installation Manual

Page: 29 / 72

Stabilize the Rack for Installation
■
“Stabilize the Rack for Installation” on page 29
■
“Install Mounting Brackets” on page 30
■
“Mark the Rackmount Location” on page 31
■
“Connect AC Power Cables Before Installing Tool-less Slide-Rails in Sun Rack II
1042” on page 33
■
“Attach Tool-Less Slide-Rail Assemblies” on page 35
■
“Install the Storage Server Into the Slide-Rail Assemblies” on page 38
■
“Verify Operation of Slide-Rails and Cable Management Arm” on page 53
■
“Install the Cable Management Arm” on page 40
Stabilize the Rack for Installation
Caution - To reduce the risk of personal injury, stabilize the rack cabinet, and extend all anti-tilt
devices before installing the storage server.
Refer to your rack documentation for detailed instructions for the following steps.
1.
Open and remove the front and rear doors from the rack cabinet.
Note -
The front and rear doors need to be removed only if they impinge on the mounting bay.
2. To prevent the rack cabinet from tipping during the installation, fully extend the
rack cabinet's anti-tilt legs or anti-tilt bar, which are located at the bottom front of
the rack cabinet.
3. If there are leveling feet beneath the rack cabinet to prevent it from rolling,
extend these leveling feet fully downward to the floor.
Caution -
When moving the rack to a new location, including repacking, verify that the leveling
feet are up before moving the rack.
4. After the cabinet is installed in its location, you can use the shipping brackets to
secure the cabinet to the floor.
Caution -
Shipping brackets are not for use for bracing or anchoring the rack during seismic
events.
Installing the Storage Server Into a Rack 29