Warning: Do not allow any metal shavings to remain in the equipment area. Metal
Shavings may result from over tightened screws or bolts. These small metal particles
are hazardous to electronic equipment. Be careful not to over tighten screws or bolts.
Warning: Do not use tie wraps on or above the top traverse arms on a frame. Always
trim tie wrap flush and turn the trimmed tie wrap to the rear of the cable.
Caution: All personnel associated with the installation of these systems must adhere to
all safety precautions and use required protection equipment, to avoid the possibility of
injury to personnel, service degradation, and/or service interruption.
Caution: These systems have redundant power supplies to allow service during normal
maintenance. When repairs require a total power disconnect, both input supply sources
must be disconnected. This causes service interruption and takes down the systems.
Caution: This equipment has a connection between the earthed conductor of the DC
supply circuit and the earthing conductor.
Caution: The Branch Circuit Overcurrent Protection shall be rated minimum -48V,
maximum 60A.
Caution: Equipment is to be installed in restricted access areas in accordance with articles
110-16, 110-17, and 110-18 of the National Electric Code, ANSI/NFPA 70.
Caution: A readily accessible disconnect device that is suitable, approved, and rated
shall be incorporated in the field wiring.
Caution: Connect to a reliably grounded SELV source which is reliably earthed and
electrically isolated from the AC source.
Caution: Use only listed closed loop connectors for connection to the supply.
Note: Use a minimum of 26 AWG telecommunications line cord for connection to the modem.
Regulatory Compliance and Certification
Tekelec products are tested to meet the following regulatory standards:
22
910-6535-001 Revision D, February 2014
Safety and Pre-Installation Requirements
Hardware and Installation Manual
