Oracle Dual Port 25 Gb, User Manual

Page: 40 / 88

Configure the Network Interface (Oracle Solaris x86)
Configure the Network Interface (Oracle Solaris x86)
1.
Display the
bnxt
instances.
# dladm show-phys
For more information, refer to the Oracle Solaris
dladm
(1M) man page.
The output should be similar to this:
LINK MEDIA STATE SPEED DUPLEX DEVICE
net9 Ethernet up 25000 full bnxt1
net8 Ethernet up 25000 full bnxt0
2.
Set up the
bnxt
interfaces.
For more information, refer to the Oracle Solaris
ipadm
(1M) man page. Your
ipadm
command
might look similar to this:
# ipadm create-ip net4
# ipadm create-addr -T static -a local=10.2.3.4/24 net4/v4
This command creates another address
10.2.3.5/24
on interface
net1
, but marks the address
down until explicitly marked up:
# ipadm create-addr -T static -d -a 10.2.3.5/24 net4/v4
This command marks the address object
net4/v4a
up that was previously marked down.
# ipadm up-addr net4/v4a
Related Information
■
“Configure the Network Interface (Windows)” on page 40
■
“Boot Options” on page 41
■
“Installing RoCE” on page 44
Configure the Network Interface (Windows)
Use the Network and Sharing Center to configure the network settings for the
bnxt_en
adapter.
These steps are for Microsoft Windows7.
1. Ensure that the adapter is installed.
40 Oracle Dual Port 25 Gb Ethernet Adapter User's Guide • September 2017