www.opwglobal.com
Document #:
M00-20-7074 Rev. 005
Page 10 of 32
3. Typical Installations for the Wireless Petro-Net Modem®
This section covers the various mounting and wiring instructions for typical Wireless Petro-Net Modem
®
installations.
3.1
Typical Installations
The Wireless Petro-Net Modem
®
can be set up to work with various installations:
SiteSentinel
®
iSite™
FIT with Remote Antenna
Multiple FITs
FSC with Modem-Mounted Antenna
FSC with Remote Modem
Check with local authority for suitability of installation.
FSC with Remote Antenna
3.2
FIT-Mounted 6 in antenna
FIT-Mounted 6 in antenna is not suitable for all applications
When setting up the Wireless Petro-Net Modem
®
, you can install the antenna directly onto the FIT.
1. Connect the power supply to the power terminals in the FIT.
2. Place the modem on the bottom of the FIT.
3. Locate and drill a .375-inch hole for the antenna cable, seal this hole with silicone sealant.
4. Locate a position on the pedestal to install the antenna, drill a .25-inch hole for the connector.
5. Remember to keep line-of-sight with the FSC antenna, (e.g. this cannot be blocked by vehicle traffic at
the island) otherwise proceed to FIT with remote antenna mounting.
Figure 3-1 FIT-Mounted Modem Power Supply
6. Locate the power supply behind the main board.
7. Connect the power cable to the power connector on the system.
8. Connect the Petro-Net cable at this time. (Black wire to Terminal 1; White wire to Terminal 2).
