Opus Coverator 330, User Manual

Page: 4 / 15

User guide Coverator 330
4
O
PERATION
:
1. S
TARTING THE EQUIPMENT

Plug the equipment into the power socket, turn ON by the main switch at the side,
red & green LEDS flash and hear a short bleep. The pre-heating process will start.
Tined

Pre-heat time for the Coverator is about 8 minutes. When the Coverator is ready
to operate, the green LED light at the front comes on.

Set the lever maximally to the left. (see
DIAG
: opposite )
2. D
ESCRIPTION OF
LED’
S SIGNALS AND SOUNDS
At the front on the right side of the equipment are two LED lights indicating the status
of equipment:

Switching on the equipment you will see the red & green LED’S at the front flash
and you will hear a short bleep.

Red LED on and green LED off
– this means that the equipment is on but the
rollers are not hot enough.

Red and green LED’s are on an audible bleep sound – this means that rollers have
reached temperature and informs you that the equipment is ready to use.

Red LED flashes and the green LED is off
– it means that the temperature sensor
is damaged. Call the suppler or service team.

Red LED is on and the green LED flashes and there is an additional audible signal
– this means that the heater or the temperature regulator is broken.
Call the suppler or service team.
3. P
REPARING THE COVER

Use a trimmer to cut your printout according to the
O•pouch-covers
template. In
each box of
O•pouch-covers
there is a template with the correct dimensions.

Take the trimmed printout and place it in the laminating Pouch Cover.

The pouch must cover all the trimmed printout surface.

When laminating O•Pouch Covers you must use a paper carrier supplied in the box
of covers.
4. L
AMINATION OF
O•
POUCH COVER

Slowly insert the O•Pouch Cover in the carrier to the front slot (see
DIAG
:) with the
closed edge first and the printout face up in the middle of the slot.

When Inserting the cover in the front slot, it is confirmed by 1 bleep.

The cover will move through the unit and exit at the back laminated.

3 bleeps indicate the end of the laminating process and the cover is out.

After the 3 bleeps remove the cover from the back straightaway or the cover will be
damaged.

When a paper carrier is not used or the O.Pouch Cover slips out of the carrier while
laminating, there is a big risk of putting glue on or damaging the rollers.
SEE CLEANING SECTION PAGE 6