21
3. Installation
3.1 Composition and assembly ofthe
loop
The loop is composed of the 3 following
elements: a loop cable, a loop adapter and a
connecting cable.
The loop is delivered « ready for use » but it is
possible to disassemble it to adapt it to the
reception desk Shape. See below.
To disassemble the loop that will equip the
counter, first unscrew the support of the elec-
tronic card.
Connect the beginning and the end of theloop
cable to the circuit board (red connector).
Then plug the 50-70 cm connecting cable sup-
plied, to the "amplifier" connector of the adap-
ter and to the "Loop" terminal block of the am-
plifier.
Your loop is now created andconnected.
3.2 Installation of the loop in the coun-
ter
1.
There are several possibilities to install a loop
in a counter as described below, however we
strongly advise you to use the first version:Place
the loop on the vertical and horizontal portion of
the counter as shown in figure 1. This type of
installation ensures better coverage in front of
the counter.
Figure1.
Note:
The loop cable supplied in the
DCL20-K kit ensures quick
installation of a
magnetic loop system for reception
, counter or cash desk.
In order to optimize the radiation of the magnetic
field and to guarantee a better result,
the wire
should be placed close to thecustomer.
Loop
amplifier
DCL20-65 | Manuel d’installation et d’utilisation | Installation and user manual |
Summary of Contents for DCL20-65
