CR Series
Ref. 1830-SU-02-N
Page 22
Start of operation
1. To operate the CamRecord CR cameras, please select first the IP
address of the GigE Network as it is described in the “GigE
Network” user manual. Make sure, that your Laptop (PC) provides a
Gigabit Ethernet (GigE) interface.
After selection of the IP address, the software (CamControl or
TimeBench) can be installed.
2. When IP address is selected and software are already installed, the
camera can be operated directly:
Please connect the camera power supply to the power connector of
the CR camera and connect then the power supply to the 110-
240 Volt power source. The camera will operate immediately when
connection to the power supply is done. The green LED above the
power connector will glow green
Please connect then the GigE (Cat 6) cable to the Laptop (PC) and
to the connector of the camera.
Switch on the CamControl or TimeBench software on your Laptop
(PC). The software will start automatically and will connect the
Laptop (PC) to the camera.
3. To verify immediately the operation of the camera, the following
parameters in the “Setup-Menu” of the software can be selected:
Frame Format:
800 x 600 (CR450x2)
1024 x 1024 (CR450x3)
1280 x 1024 (CR600x2)
1280 x 1024 (CR1000x2 (x3))
1696 x 1710 (CR3000x2)
512 x 512 (CR5000x2)
2304 x 1720 (CR 4000x2)
Frame Rate:
50 fps
Exposure Time:
1/50
Synchronisation:
internal
Select then “Video-Live” in the “Acquistion-Menu”. The camera
transfers now live-images to the monitor of the Laptop (PC).
To optimize now the image in a most simple way, please open or
close the iris and adjust the focus of the lens.
Summary of Contents for CamRecord CR Series
