HD3000
5-5
No
Step
Procedure
Photo
Hardware
setup
. Set the Jumper.
(Before excuting
program, please
open top cover to
set jump)
Note:
Set jumper &2 on.
2
Soffware
Setup
procedure
Excute “updateugen-
num” program.
3
Next
. Update program
picture will show.
2. Select Port Com then
connect PC and
HD3000 by RS232
cable.
(Program will connect
automatically, clicking
“Connect” button is
not needed.)
4
Next
Click “Device5” button
to select file to update
GENNUM.
Note:
Please make sure to
select the correct file
“device5.bin”.
2. GENNUM (System Bias)
Note:
Be careful! When updating the software, failure is not allowed. It will
cause all system failed and unrecoverable. The only way to recover
the failure is to change flash.
