User Controls
Automatic: Enable or disable Automatic to automatically select
the appropriate settings.
Enabled - the projector will automatically select the
appropriate settings.
Disabled - the projector won’t automatically select the
appropriate settings.
Frequency: Change the display data frequency to match the
frequency of your computer's graphic card. When you
experience a vertical flickering bar, use this function to make an
adjustment.
Phase: Synchronize the signal timing of the display with the
graphics card. If you experience an unstable or flickering
image, use this function to correct it.
H Position: Adjust the horizontal position.
V Position: Adjust the vertical position.
White Level: Allow user to adjust White Level when inputting
SVideo or Video/CVBS signals.
Black Level: Allow user to adjust Black Level when inputting
SVideo or Video/CVBS signals.
Saturation: Adjust a video image from black and white to fully
saturated color. Press the
t
to decrease the amount of color in
the image. Press the
u
to increase the amount of color in the
image.
Hue: Adjust the color balance of red and green. Press the
t
to increase the amount of green in the image. Press the
u
to
increase the amount of red in the image.
IRE: Adjust measurement of composite video signals.
Black Level (for HDMI): Allows user to adjust the Black Level
for HDMI signals.
Signal Power On
Off: Projector can only be turned on by pressing the "Power"
button.
On: Projector turns on automatically when an active signal is
detected.
"IRE" is only supported
on NTSC signal.
N
ote
N
ote
