© Optoma
Issue 2.1 July 25, 2018
16
2
Basic Switcher Set-Up
Inspect the shipping box and make sure that no damage was caused during transportation. If you
see any damage, immediately contact the shipping carrier. Remove the unit and ensure that there
is no damage caused during shipping.
STEP 1:
Verify that the following items are included with the unit:
3 pin plug IEC mains cable
CD (with documentation)
Quick Start Guide (QSG)
STEP 2:
Install the unit on a clean flat surface or on an equipment rack using the rack-mount ears. The
unit should always be installed in a well ventilated, static free environment and close to the AC power
source. Max. operating temperature is 0
0
C to 40
0
C and 5% to 95% non-condensing humidity.
STEP 3:
Connect the display device (Monitor, LED Wall, Projector, etc.) to one of the output
connectors DVI/HDMI are available on all models, and SDI or HDBaseT are featured only on certain
models. If applicable, connect the speakers or external audio amp to the audio output connectors.
STEP 4:
Connect the Input sources (Blu-Ray Player, Set Top Box, PC, etc.). Use connectors from
different groups to achieve the ¼ sec ultra-fast switching. Groups are identified by the button color on
the front panel. If applicable, also connect any audio sources to the 3.5mm stereo jacks.
STEP 5:
Insert the power cord and power-up the unit. The boot-up process takes about one minute.