English
Installation
Warning Indicator
▀
■
When the “LAMP” indicator led
“
”
is lit orange, the
projector will automatically shut down. Please call the
nearest Optoma facility for assistance.
▀
■
When the “TEMP” indicator
“
”
turns red, it indicates the
projector has overheated. The projector will shut down
automatically.
Under normal conditions, the projector can be switched on
again after it has cooled down.
▀
■
When the “TEMP” indicator
“
”
flashes red, it indicates the
fan has failed.
Powering Off the Projector
1. Press the
“ ”
button on the remote control or
“
”
button
on the rear side
of the projector two times with one second
interval in between
to turn off the projector. First push of
button will display the following message on the screen.
Press the button again to confirm the shut down. If the
button is not pressed, the message will disappear in 5
seconds.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the Power LED
“
”
will turn blue.
When the light is solid red, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
“
”
button on the rear of the projector or
“
”
on the
remote control
to restart the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.
Contact the nearest
service center if the
projector displays these
symptoms. See page
57 for more information.
N
ote
N
ote