Optoma BX-CTA16 UST, Installation Instruction

Page: 14 / 18

English 14
2. Rotate the lens counter-clockwise by a quarter and remove the UST lens.
Change back to the non-UST lens after using the UST lens
To install non-UST lens, follow the steps below.
1. In the proejctor menu, follow these steps to switch back to non-UST mode: Option > Service > UST Lens
Install > None.
Notee:
To enter service menu, enter the service password.
2. Turn off the projector.
3. Disconnect from AC power.
4.
Remove the UST lens. See “Removing the UST lens” on page 13 .
5. Replace the UST lens boresight module with the non-UST boresight module. See “Releasing the UST
lens boresight module” on page 14 .
6. Change back to the non-UST lens.
7. Power on the projector with AC power on.
8.
Complete the lens calibration process by pressing “Lens, Enter” on keypad or “Lens H or Lens V, Enter”
on remote control.
Releasing the UST lens boresight module
To uninstall the UST lens boresight module, follow the steps below.
1. Release the lens cable from the UST lens boresight module.