English 11
Turning the projector on
To turn on the projector after UST lens has been installed, follow the steps below.
1. Connect the AC cable and ensure the power is switched on.
2. Ensure the lens correctly installed in the projector.
3. Ensure no personnel or no object is in the beam path before projector turning on.
4. Turn on the projector by pressing the power key on the remote controller or on the projector’s built-in
keypad.
Image adjustment
Please note the items below when completing the initial image adjustment.
1. Limited lens shift is allowed.
2.
Source input is not available.
3.
If Lens Focus Adjustment does not make the image clear, follow the steps in Boresight Adjustment for
boresight fine-tuning.
4.
Press “Pattern” to switch test patterns.
5.
Press “Exit” to exit this adjustment process.
Lens focus adjustment
To make up the tolerance between lens and DMD chips, user would need to adjust back focus to make the screen
distinct. “ZOOM” button on remote control is for back focus length adjustment and “FOCUS” button is for floating
focus adjustment.
1. Adjust back focus length to make the area of point 5 clear and sharp.
1
2
4
5
8
9
6
7
3
2.
Adjust focus to make screen corners (point 1, 3, 7, and 9) clear and sharp.
3.
Repeat step 1 and step 2 on full screen to balance center and corner resolution.
Summary of Contents for BX-CTA16 UST
Page 1: ...A16 UST Lens INSTALLATION INSTRUCTION ...
Page 18: ...www optoma com ...
