English 35
USING THE PROJECTOR
Color Matching
Color
White
R
G
B
Reset
Exit
Color Space (non-HDMI input only)
: Select an appropriate color matrix type from the following:
AUTO, RGB, or YUV.
Color Space (HDMI input only)
: select an appropriate color matrix type from the following: Auto,
RGB(0-255), RGB(16-235), and YUV.
White Levele:
Allow user to adjust White Level when inputting Video signals.
Notee:
White level can only be adjusted for Video/S-Video input sources.
Black Levele:
Allow user to adjust Black Level when inputting Video signals.
Notee:
Black level can only be adjusted for Video/S-Video input sources.
IREe:
Allow user to adjust IRE value when inputting Video signals.
Notee:
IRE is only available with NTSC video format.
IRE can only be adjusted for Video input sources.
Signal
Adjust the signal options.
Automatic
: Configure automatically the signal (the frequency and phase items are grayed out). If
automatic is disabled, the frequency and phase items will appear for tuning and saving the settings.
Frequency
: Change the display data frequency to match the frequency of your computer’s graphic
card. Use this function only if the image appears to flicker vertically.
Phase
: Synchronize the signal timing of the display with the graphic card. If the image appears to be
unstable or flickers, use this function to correct it.
H. Position
: Adjust the horizontal positioning of the image.
V. Position
: Adjust the vertical positioning of the image.
Exit
: Exit the “Signal” menu.
Notee:
Signal can only be adjusted for RGB/Component input sources.
Brightness Mode (Lamp base data)
Adjust the brightness mode settings for lamp-based projectors.
Bright
: Choose “Bright” to increase the brightness.
Eco.
: Choose “Eco.” to dim the projector lamp which will lower power consumption and extend the
lamp life.
Dynamic
: Choose “Dynamic” to dim the lamp power which will be based on brightness level of the
content and adjust lamp power consumption between 100% and 30% dynamically. The lamp life will
be extended.
Eco+
: When Eco+ mode is activated, the brightness level of the content is automatically detected to
significantly reduced lamp power consumption (up to 70%) during periods of inactivity.
Summary of Contents for 3600ANSI
Page 1: ...User manual DLP Projector ...
Page 16: ...English 16 SETUP AND INSTALLATION Type 1 8 IO MOLEX MOLEX 1 8 2 3 14 11 4 7 6 13 5 10 12 ...
Page 17: ...English 17 SETUP AND INSTALLATION Type 2 9 IO MOLEX MOLEX 1 8 2 3 11 4 7 6 13 5 9 12 10 14 ...
Page 73: ...www optoma com 36 7AZ01G001 A P N 36 7AZ01G001 A ...