1. 0 deg - each time after homing the device,
the attenuator instantly will go to defined
position (0 degree).
2. Last position - each time after homing the
device, the attenuator will go to last position
before .
3. OFF - each time after homing the device,
the attenuator will remain in home position.
8. Select if automatic homing is required after
turning the device ON.
9. Choose if physical buttons are required, if no, you
can lock them by choosing “Buttons OFF”.
10.After finishing the calibration routine you will be
greeted into MAIN window
NOTE:
After homing the device message box will appear
4.5.3. Main window
The calibration procedure is done successfully if there is no error, device is connected and homed. The device is ready to use.
11
Preset buttons
Click “Edit” to add or edit
preset t values for a quick
change
Settings
Select this icon to open
calibration and settings
window
Angle value in deg
Enter required power value.
Press “Enter”.
Power Slider
Move the slider to change
angle
Buttons for incremental
change
Click grey button to rotate
clockwise or counter-
clockwise.
Save as preset
Save current angle as preset
button in required slot.
Angle value in radians
Click double arrows to switch
units (to operate in radians).
Homed
Green
-
device is
homed
Connection
Green
-
device is
connected
Status
Green
-
if blinking
device is in
motion
Error
Red
-
indicates and error. Drag
cursor here to obtain error
Reconnect
Select this icon to reconnect
the device if it is disconnected
Sliding Menu
Drag cursor here to expand
menu
Command line
Select this icon to open
command terminal window
Device selector tab
Connected device tab
About
Click to open About window
for manual
