A10.1018
Hold on the mechanical stage support device (figure 2), place it from the top of the guide board
(figure 1), let the device (figure2) falling free until it reach the limit position. Use the hexagon
wrench screw down the locking block; make the stage support device (figure1) and the guide
board fixed together.
The mechanical stage have been adjusted horizontally and fixed together before leaving
factory. Do not disassembly unless necessary, that may affect the observation precision
of the instrument.
2-2-2 Installing the Trinocular Viewing
Unit
Insert the trinocular viewing unit (figure4) into
the microscope head (figure5), turn to a
proper position, then use the hexagon wrench
screw down the bolt to fix ( See figure 5 ).
2-2-3 Installing and Replacing the
Lamp (figure 6)
Please use the specified halogen Lamp
6V30W.
1
．
Hold to the bulb after you wrap it with gauze
or other protection materials, and then
deeply insert it into the lamp holder.
2. Replacing Lamp when using or soon after
When using, or soon after it is turned off, the
lamp, the lamp house and nearby parts will
be very hot and will cause serious burns.
Please turn the main switch on
“O” (off), pull
out power plug, and make sure the bulb, the
lamp room and periphery are all cool. Then,
you can do your replacing.
Please insert the lamp gently, or it will be
damaged by excessive extrusion
Do not touch the Halogen bulb with your
bare hands. It will shorten the service life
or cause it to burst. If you leave finger
marks on the surface carelessly, clean it
with a dry soft cloth.
4
5
Bolt
6
Bolt
Lamp House Bolt
