This product is a part of the system product which complies with the CE marking.
Please refer to the instruction manual of your system product for the safety instructions related to the CE marking.
INSTRUCTIONS
Connecting to the microscope frame
Lay out the cable by attaching the cable holders provided with the coded revolving nosepiece on the back side
of the microscope frame as shown below.
* If the cable holder positions are significantly deviated, the cable may not reach the connector. Attach the
cable holders while making sure that the cable reaches the connector.
BX43F
BX63F
Align with the
height of the groove
on the microscope
frame.
Align with the right
edge of the label.
Cable for coded
revolving nosepiece
Cable for coded
revolving nosepiece
When connecting to the control box for coded function (U-CBS) or the interface for coded nosepiece (U-IFRES)
Refer to the instruction manual provided with U-CBS.
Item
Specifications
U-D7RES
Dimension
119.5 (W) x 134.5 (D) x 47.2 (H) mm
Weight
1.1 kg
U-D6RES
Dimension
107.5 (W) x 116 (D) x 48.2 (H) mm
Weight
0.7 kg
Before disposing of this product, be sure to check the regulations and rules of your local government and follow
them. Contact Olympus for any questions.
1
Cable connection
2
Operating procedures
3
Specifications
For the operating procedures, refer to the instruction manuals provided with BX43F, BX53F2, BX63F and U-CBS.
* When combining U-D6RES with BX63F, select [U-D7RES] in the revolving nosepiece settings on the touch
panel controller provided with BX63F.
If you connect to the microscope frame (BX53F2), refer to the instruction manual provided with BX53F2.
A X 7 9 1 6 U-D7RES/U-D6RES
AX7916 05
CODED 7 POSITION NOSEPIECE / CODED 6 POSITION NOSEPIECE
U-D7RES / U-D6RES
Connecting the coded revolving nosepiece (U-D7RES/U-D6RES) to the microscope frame (BX43 or BX53F2) makes it pos-
sible to use the light manager function of the microscope. Also, connecting the coded revolving nosepiece (U-D7RES/U-
D6RES) to the microscope frame (BX63F) or the control box for coded function (U-CBS) makes it possible to read out the
hole position information of the coded revolving nosepiece.
Align with the
height of the edge
between the back
side and upper side
on the microscope
frame.
