SNAP PAC Racks
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
SALES 800-321-6786 • 951-695-3000 • FAX 951-695-3095 • [email protected] • SUPPORT 800-835-6786 • 951-695-3080 • FAX 951-695-3017 • [email protected]
© 2007–2016 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
SNAP P
A
C R
a
cks
PAGE
6
DA
TA
S
H
E
E
T
F
o
rm 168
4-1
6
0
506
Assembling the Circuit Board, Rack Extrusion, and Din Clips
Push down hard on the other edge to snap the
board into place.
Insert one edge of the circuit board into the
extrusion.
1.
3.
Attach one DIN clip to each end cap using the
slots in the end caps as shown.
4.
(This step only for racks with three or more clips.)
Slide one DIN clip to the middle position and
secure with the rivet provided. For racks with four
clips, add an additional middle clip.
2.
Using the screws provided, secure an end cap and
DIN clip assembly to each end of the extrusion.
5.
Removing the Circuit Board from the Rack
Extrusion
If end caps are present, remove them. Then insert a flathead
screwdriver in one of the circuit board release notches and pry
up the board. Repeat in the other release notches until the
board pops out of the extrusion.
Rivet
(included)
2
3
4
1
5
Attaching the Adapter Clip to a DIN Rail
1.
Hook the DIN-rail clip over the top of the DIN rail.
2.
Using a screwdriver, pry open the DIN-rail clip flange at
the bottom of the clip. Push the clip toward the DIN rail.
3.
Snap the DIN-rail clip into place
DIN rail
Extrusion
assembly
