14
Web Setting Function
：
Transmitter/receiver provide detail settings over web browser, you have to know the IP address
before setting.
There are three ways to get the IP address of receiver:
1.Local IP shows on right bottom screen when booting.
2.Press remote control button
(IP Address)
3.Install Internet explorer plug-in: Bonjour , click device name to enter web setting page to get the
IP address(please refer software installations manual)
There are two ways to get the IP address of transmitter:
1.Connect a transmitter and receiver and set in the same channel, press remote control button
at receiver side (Host IP Address), it will shows the transmitter IP Address on
screen(must remove the HDMI cable of transmitter or turn off the video source).
2. Install Internet explorer plug-in: Bonjour , click device name to enter web setting page to get the
IP address(please refer Bonjour plug-in installation)
System default IP setting is Auto IP, it will assign 169.254.X.X (subnet mask 255.255.0.0) to
transmitters and receivers, you could also set to DHCP or Static IP.
You computer must set in same subnet mask to enter the web setup page.
If you do not sure the IP address of transmitters/receivers you could reset the transmitters and
receiver to default.
For transmitters: press the LINK button to power on (Press and hold until Green and Blue LED
Flash) to reset to default.
For receivers: press remote control
to reset to default.
Summary of Contents for DKM01B
Page 4: ...4...