IR Speed Dome Installation Manual
5
Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
Warnings
: Serious injury or death may be caused if any of these warnings are neglected.
Cautions
: Injury or equipment damage may be caused if any of these cautions are neglected.
Warnings
Follow these safeguards to prevent serious
injury or death.
Cautions
Follow these precautions to prevent potential
injury or material damage.
Warnings
In the use of the product, you must strictly comply with the electrical safety regulations of the nation and region.
Please use the power adapter which is provided by normal company. The adapter should be AC 24V/3A according to dome
model.
Do not connect several devices to one power adapter as an adapter overload may cause over-heating and can be a fire hazard.
Please make sure that the power has been disconnected before you wire, install or dismantle the speed dome.
When the product is installed on a wall or ceiling, the device should be firmly fixed.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power cable, then contact the service
center.
If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble
the camera yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or maintenance.)
Cautions
Do not drop the dome or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the
equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
Do not place the dome in extremely hot, cold (the operating temperature shall be -30°C ~ +65°C), dusty or damp locations, or
fire or electrical shock will occur otherwise.
The dome cover for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can
cause fire danger).
Do not aim the camera at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfunction
however), and affecting the endurance of sensor at the same time.
Please use the provided glove when open up the dome cover, avoid direct contact with the dome cover, because the acidic
sweat of the fingers may erode the surface coating of the dome cover.
Please use a soft and dry cloth when clean inside and outside surfaces of the dome cover, not to use alkaline detergents.
Do not stare at infrared lights closely to avoid hurting your eyes when the infrared lights are on.
Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type only.
Dispose of used batteries according to the instructions provided by the battery manufacturer.
