UMX-CC version 1.0
9
AUDIO IP MANAGEMENT CARD
FOR UMX-02/0 MODULAR MATRIX
UMX-CC
R&D Department
3.2.
Positioning the card in the UMX-02/0 chassis and connections
1.
Move the front switch on the UMX-02/0 to
the OFF position or disconnect the power
strip.
2.
Unscrew the two attachment screws and
remove the blank panel from the position
where the card has to be installed.
3.
Insert the card.
4.
Fasten the attachment screws.
5.
Connect the UMX-CC card to the IP network
of the installation by means of RJ45
connector
A
or
B
.
6.
Connect the power supply to the UMX-02/0
chassis and move the front switch to ON.
3.3.
Adding the card to the installation by means of the P.A. Manager
software
To configure the card, it is necessary to have a PC connected to the network that has the SCF-01 or SCM-
01 (P.A. Manager) software.
1.
If the software is the SCM-01, start the application, open the
Options
menu and select
Installations
(administrator user level is required). If the software is the SCF-01, start the application.
NB:
Prior to configuration of the parameters of the UMX-CC card, it is necessary to have configured the Installation and PA Area
parameters.
The UMX-CC card must be added to
a UMX-02/0 chassis, which in turn
can depend on a P.A. Area or a DVA-
102ETH.
2.
Select the UMX-02/0 chassis to
which you wish to add the UMX-CC
card.
3.
Open the
Add Equipment
menu, select
UMX-02
and click on
UMX-CC
.
4.
The unit configuration screen appears.
Refer to section
3.4. Configuration of
the parameters of the UMX-CC card
.
Figure 3
