14
Screw in the “Tilt Range Knob” as shown and just nip up.
Using a screwdriver, screw in the small “Tilt Range Screw”
and tighten up.
Next, screw on the “Tilt Adjustment Knob” as shown and just
nip up.
INSTRUCTIONS FOR USE
Remove the cable tie and unravel the cordset before operation.
HEAD TILT
The fan and motor assembly can be
tilted up and down to your desired
angle.
To adjust the tilt angle, loosen both the
larger “Tilt Adjustment Knob” and the
smaller “Tilt Range Knob” then tilt
the head to the desired angle and then
tighten both knobs tight.
FAN ON / OFF / SPEED
Rotate the knob located on the rear of the motor housing to
position I for a low speed, 2 for a medium speed and 3 for a
high speed.
Rotate the knob to position 0 to switch the Fan off.
OSCILLATION
Press the clutch knob down to activate the oscillating function.
The fan head will swing from side to side whilst blowing air.
To stop oscillation, allow the Fan head to move into the desired
position and then pull the clutch knob up.
CARE AND CLEANING
• Turn off and unplug the unit prior to cleaning.
• The grilles can be cleaned by vacuuming with a brush at
-
tachment.
• To clean the blade, first remove the front grille / cowl as
-
sembly by unscrewing the small screws around the edge of
the rear safety grille.