10
Description of the Device
1. Transport handle
2. Thermostat hand wheel
3. Power switch
4. Place for power cord
5. Radiator’s fins
6. Wheels
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must
attach them before operating the heater.
WARNING: Do not operate without feet attached.
Do operate the heater only in upright position (feet on the
bottom, controls on the top), any other position could create
a hazardous situation.
1. Place the radiator body upside-down on a scratch-free
location, make sure it is stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided,
attach the U-shaped bolt to the U-facing flange between first
and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body, you
should insert the threaded ends of the U bolt in the holes on
the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing
nut properly.
Note: do not over tighten, which may cause the damage
of radiator flange.
5. Screw off spherical nut from the castor, align the shaft to the
hole of the castor mounting plate, insert in, and screw on the
spherical nut.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of
the rear castors.
Note: the rear castors must be mounted between the end
two fins.
INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and
stable surface. Damage may occur if it is placed on an
incline or decline.
2. Set all the controls to OFF position and insert the plug into
a socket-outlet with well grounded. Be sure that plug fits
firmly.
3. Rotate the thermostat knob clockwise to MAX position and
switch the heater on as follow: the switch I for low heat, the
switch II for medium heat and both switches on for high
heat.
4. When your room reaches the desired temperature, now
slowly rotate the thermostat knob counter clockwise until
the pilot light goes out. The thermostat can now be left at
this setting. As soon as the room temperature has dropped
below the set temperature, the unit will switch it self on
automatically until the set temperature has been reached
again. In this way the room temperature remains constant
with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate
the thermostat knob clockwise to raise the temperature,
or counter clockwise to lower it.
6. This heater includes an overheat protection system that
shuts off the heater when parts of the heater are getting
excessively hot.
7. To completely shut the heater off, turn all the controls
to OFF, and remove plug from the socket-outlet.
MAINTENANCE
1. Always remove the plug from the socket-outlet and allow
the radiator to cool down before clean the heater.
2. Wipe radiator with a soft damp (not wet) cloth.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents
and abrasives.
Do not allow the interior to get wet as this could create
a hazard.
3. To store away the heater, wind the cable round bobbin and
store the heater in a clean dry place.
4. In case of malfunction or doubt, do not try to repair the
radiator yourself, it may result in a fire hazard or electric
shock.
IMPORTANT:
• Do not connect the radiator to a power source before
assembly.
1
2
3
5
4
6
Summary of Contents for OST-1611
Page 1: ...Grzejnik olejowy OST 1611 PL Instrukcja obsługi 6 UK Operating Instructions 9 ...
Page 4: ...4 ...
Page 5: ...5 ...