Optimum OK-2090, Operating Instructions Manual

Page: 14 / 51

14
Return the central filter to the dirt container. Replace the dirt
container as directed.
Post-motor Filter
NOTE: This is located on the back of the vacuum cleaner.
Release the post-motor cover by pressing down on the two
catches at the top of the cover.
The post-motor filter can be rinsed In warm water (max 40°C).
Allow to air dry for at least 24 hours before replacing.
Return the post-motor filter to the casing and re-fit to the back
of the vacuum cleaner.
6. Storage
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet and rewind the power cord as
directed before storing.
NOTE: Always store the vacuum cleaner base down.
7. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing maintenance
or troubleshooting checks.
PROBLEM: Vacuum cleaner won’t run
Cause: Not properly plugged Into electrical outlet.
Solution: Plug In securely.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum cleaner.
Leave for one (1) hour before switching the vacuum cleaner
back on.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause: Dirt container not installed properly.
Solution: Review dirt container replacement.
Cause: Dirt container full or blocked.
Solution: Empty dirt container.
Cause: Clogged filters.
Solution: Remove, clean and replace filters.
PROBLEM: Accessories won’t pick up.
Cause: Accessories are not attached correctly.
Solution: Refer to section 5.
Cause: Hose is not installed correctly.
Solution: Refer to section 6.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause: Dirt container full.
Solution: Empty dirt container.
Cause: Dirt container not Installed correctly.
Solution: Review dirt container replacement.
Cause: Hose Is not installed correctly.
Solution: Review installation.
Cause: Filter not installed completely.
Solution: Remove, clean and replace filters.
8. Technical Specification:
Voltage: 220-240V~50Hz
Wattage: 1800-2000W max
Capacity: 2 litres approx
Cord length: 5m approx
Noise Level: 82 dB/A/
Subject to technical change without notice.
Ecology – Environmental Protection
The “crossed-out trash bin” symbol on electrical
equipment or packaging indicates that the device
cannot be treated as general household waste and
should not be disposed of into containers for such waste.
Obsolete or broken-down electrical device should be
delivered to special designated collection points, organized
by local public administration, whose purpose is to collect
recyclable electrical equipment.
This way, each household helps reduce possible negative effects
influencing natural environment and allows the reclaiming of
materials which the product is made of.
Weight: 5,4kg
e
Fig. 5/6