Optimum 3338165, Operating Manual

Page: 16 / 86

Version 1.1.0 - 2020-08-07 16 Translation of original instruction
MH35G │ MH35V EN
M
H
35
G
_M
H
35
V
_
GB
_
1.
fm
1.9.4 Separation guard
Adjust the guard (1) to the correct height
before you start working.
To do so, slacken the clamping screw, set
the required height and re-tighten the
clamping screw.
There is a switch integrated in the spindle
protection mounting which monitors the
closed position.
INFORMATION
The machine cannot be started, if the spin-
dle protection is not closed.
Img.1-3: Separation guard
1.10 Safety check
Check the milling machine regularly.
Check all safety devices

before starting work,

once a week (with the machine in operation) and

after all maintenance and repair work.
1
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Signs,
Markers Installed and legible
Functional check
Equipment Check OK
Emergency stop button After the emergency stop button is pressed, the milling machine
must switch off. It must only be possible to restart the machine, if
the emergency stop button is unlocked and the ON switch has
been pressed.
Separation guard around
the drill and milling spindle The milling machine may switch on only when the guard is
closed.