Technical specification
Version 1.0.1 - 2020-08-18
12
Translation of original instruction
DP33
EN
D
P
33_G
B.
fm
Inform the supervisor about all hazards or faults.
Stay on the drilling machine until the machine completely stopped moving.
Use the specified personal protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.
Do not use protective gloves when drilling.
1.15
Safety during maintenance
Inform the operators in good time of any maintenance and repair works.
Report all safety relevant changes and performance details of the drilling machine or their ope-
rational behavior. Any changes must be documented, the operating instructions updated and
machine operators instructed accordingly.
1.15.1 Disconnecting and securing the drilling machine
Disconnect the mains plug before starting maintenance and repairs.
All machine parts as well as all dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
Attach a warning sign to the machine.
1.15.2 Mechanical maintenance
Remove or install protection safety devices before starting or after completing any main-
tenance work; this include:
covers,
safety instructions and warning signs,
grounding cables.
If you remove protection or safety devices, refit them immediately after completing the work.
Check that they are working properly!
1.16
Electronics
Have the machine and/or the electrical equipment checked regularly, at least every six months.
Immediately eliminate all defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Disconnect the machine immediately if there is a malfunction in the
power supply!
2
Technical specification
The following information represents the dimensions and indications of weight and the manu-
facturer‘s approved machine data for following stated machines.
Electrical connection
400V ~50 Hz , (~60Hz)
Drive motor power
1.1 kW
Drilling capacity in steel S235JR
Ø 30 mm
Continuous drilling capacity in steel S235JR
Ø 25 mm
Spindle speed ~50Hz
120 - 1810 min
-1
Spindle seat
MT 4
Drill table T-slot size
14mm diagonally running