Safety
Version 1.1.4 - 2022-09-14
74
Translation of original instruction
DH24BV | DH28BV | DH34BV | DH40BV
EN
D
H
B
V
_G
B_1.
fm
1.10
Safety check
Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation),
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the drilling machine.
are legible (clean them, if necessary),
are complete (replace if necessary).
INFORMATION
Organise the checks according to the following table;
1.11
EMERGENCY-STOP push button
ATTENTION!
Also after actuating the EMERGENCY-STOP switch, the drilling spindle is turning -
depending on the previously selected speed - for a few seconds more.
1.11.1 Main switch
In the "0" position, the lockable main switch can be secured against accidental or non-author-
ised switching on by means of a padlock.
The power supply is interrupted by switchingoff the main plug.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the main switch is switched-off.
General check
Equipment
Check
OK
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Date:
checked by (signature):
Functional check
Equipment
Check
OK
EMERGENCY-STOP
push button
After actuating an EMERGENCY STOP push button the
drilling machine must be switched off.
Drill chuck protection
The drilling machine must only be switched on, if the drill
chuck protection is closed. The engine must switch off when
the drill chuck protection is opened during operation.
Date:
checked by (signature):