Safety
Version 1.0 - 2020-12-10
14
Translation of original operating instruction
GT22
EN
GT22_G
B_1
.f
m
1.11
Personal protective equipment
For certain work, personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces or tools with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. They must be
cleaned after each use and at least once a week.
1.12
Safety during operation
WARNING!
Before switching on the surface grinding machine, make sure that no persons are
endangered and no objects are damaged.
Avoid any unsafe work methods:
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Do not work on the surface grinding machine if your ability to concentrate is reduced for any
reason, such as the influence of medication.
Clamp the workpiece securely and firmly on the table using the permanent magnet before
you switch on the surface grinding machine.
The surface grinding machine may only be used for grinding metal workpieces. No combus-
tible material or material made of wood or plastic may be used.
Only use personnel with experience in surface grinding to operate and maintain the surface
grinding machine.
The Operating Instructions must be read before using the surface grinding machine for the
first time.
Before the grinding process, check the grinding wheel and its correct direction of rotation.
Let the grinding wheel run freely for about 5 minutes.
Before starting the surface grinding machine, ensure sufficient safety clearance between
the workpiece and the grinding wheel.
The area around the surface grinding machine must be kept clean and dry. Remove waste
and material removal.
Use the magnetic clamping device to fix the workpiece, clean the clamping device before
fixing the workpiece, regrind if scratches occur.
Never leave the surface grinding machine unattended during operation. Switch off the sur-
face grinding machine before leaving.
After switching off the spindle motor, let the grinding wheel run out freely. Never brake the
grinding wheel with your hand, the honing device or other objects.
Never readjust the coolant supply during wet grinding. Switch off the coolant supply before
switching off the spindle motor.