Assembly
Version 1.0 2019-01-17
Page 48
Translation of the original instructions
B17Pro basic
GB
B17P
ro_b
asic_
G
B.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
Attach the clamping lever for drilling table fastening.
Fitting the drill head
Place the drill head on the column and
turn it until it is aligned with the base.
Immobilise the drill head with the two
screws in the drill head over the
toothed rack.
Screw in the spindle sleeve lever and
attach the crank of the table height
adjustment.
Insert the drilling table in the drilling
table support and clamp it with the
clamping lever.
Img.3-3:
Fitting the quick-action drill chuck
"Fitting the drill chuck“ on page 54
3.3
Installation
Check that the drilling machine foundation is horizontal with a spirit level.
Fix the foot of the drilling machine to the substructure with the holes pre-drilled for this purpose.
The design of the installation site must meet the ergonomic requirements of a workplace.
ATTENTION!
Tighten the fixing screws on the bench drill only to such an extent that a secure fixing is
ensured and a loose moving of the bench drill during operation is prevented.
Excessively tightened fastening screws, even in conjunction with an uneven surface, can cause
the base plate of the drill to break.
3.3.1
Fixing
In order to achieve the stability of the bench drill, the machine should be connected to the sub-
surface. For this purpose there are through holes at the foot of the drilling machine.
ATTENTION!
Tighten the fixing screws of the drilling machine only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand of the machine.
Drill head
Lever
Spindle sleeve
lever
Drilling column
Drilling table
