19
2.4.2 Power on / off
To turn on the Device
Press the Power key briefly (
). If the Device does not power on, perform the cold reset. See chapter 2.7.2.
As the Device initializes its file system, it splash screen displays for about 30 seconds followed by calibration screen. Every time
you perform a cold reset, these screens will also appear.
To turn off the Device, just press the Power key again. This action does not actually turn off the Device, it only turns the Device
into suspend mode. All running applications remain as you left them, until you press the Power key again to resume operation of
the Device.
2.4.3 Calibration of the touch Screen
On the initial boot-up of the Device, the
stylus calibration screen (Labeled Align
Screen)opens. Use the stylus to press and
hold briefly on the center of each target as
it moves around the screen.
If necessary, adjust the backlight on the
Device to make the screen readable.
When you feel the touch screen function
is poor or the operation does not match
the exact location it should be, please
recalibrate the screen by using the stylus
to tap the
Start > Settings >
Control Panel > Stylus
, to open the
Figure -13
Calibration
“
Calibration
” to recalibrate again.
2.4.4 To mute the Sound for H25
To mute the sound, press the
key first, and then press the
key to turn off and turn on the sound.
2.4.5 Using the Stylus
The stylus is located next to hand-strap on the right rear of the Device. The stylus function is same as the mouse on a PC. Use the
stylus to:
1)
Navigate the display, select menu item and open optional applications.
Summary of Contents for H25
Page 1: ...H25 User Manual ...