Page 8
C. If LEDs light up, good read beep is heard
but no data appears on the computer:
•
Check to see that the Computer Type
Selection matches the type of computer that
you are using.
•
Change the Intercharacter Delay setting.
Depending upon the type of computer that
you are using, the intercharacter delay will
vary.
•
If you are using a file sever, an interrupt
conflict may arise. Opticon recommends using
an RS232C CCD scanner interface on file
servers.
NOTE
: If after performing these checks, the
scanner is still not functioning, contact your
distributor or call Opticon Technical Support at
800-636-0090.
Factory Service
When calling Opticon Technical Support, please
have the unit model number and several bar code
labels readily at hand. The model number is
located near the connector end of the cable.
