RS-232 Baud rate and AUTO Installation
The baud rate could be installed with DIP switch 1,2,3.(switch 4 is only Auto
function)
Setting “1”
Setting “0”
1
2
3
4
[Baud rate switch diagram] - Black is the switch
’s position
Baud rate
Switch setting
1
2
3
4
9,600
0
0
0
0
14,400
1
0
0
0
19,200
0
1
0
0
38,400
1
1
0
0
57,600
0
0
1
0
115,200
1
0
1
0
128,000
0
1
1
0
256,000
1
1
1
0
AUTO mode
none
none
none
1
*
Auto mode
: If you want to use this function, please set the switch as above, and
then push the
“AUTO” button on the Transmitter. It will refine
display quality. We recommend you push the button when you finish
the set up.
1-6 RS-232 Baud rate and AUTO Installation
Notice:
Please DO NOT look directly into the LC receptacles of Transmitter,
while it is powered on, although it is regulated strictly enough to operate
under the Laser Class 1, classified by CDRH/FDA for eye safety.
Step 6
Connect an AC/DC power adapter to both Transmitter and Receiver as your
availability of AC outlets. You can find power indication LED lit on in the both
modules.
Figure 5
– Connection of AC/DC Power Adapter
Step 7
Power
p
ON the PC and display or connected RS-232 devices. Make sure
“POWER”, “VIDEO” and “AUDIO” indication LED lit ON, representing secure
connection of LC duplex fibers and all kinds of cables. If the cables are
connected incorrectly, the LINK ERR LED lit on.
Tip 1:
If any status LED is not ON normally after all installation as guided in
the above, we recommend you to push
“RESET” button while all
connections are set and the Transmitter and Receiver are powered in.
Tip 2:
Avoid “hot plugging” the Transmitter as this is not recommended
practice with live digital voltages.
1-5 Installation
Summary of Contents for AVFX-100-TR
Page 7: ......
