N219
Warning
Warning
Caution
0
(m)
7
5
(ft)
20
10
0
10
20
0 (ft)
6
8
10
5
7
1.8
2.4
3.0
(m)
0
0
10
20
30
40
50(ft)
0
10
20
30
40
50(ft)
0
5
10
15(m)
0
5
10
15(m)
5(ft)
0
5
1
0
1
2
(m)
2
0
10
20
30
40
60
70
50
80(ft)
0
5
10
15
20
24(m)
0
10
20
30
40
60
70
50
80(ft)
0
5
10
15
20
24(m)
0 (ft)
6
8
10
1.8
2.4
3.0
(m)
0
1m
1
2
Down Zone
When using Down Zone detection, peal off the lens surface sticker.
Down Zone
When using Down Zone detection, peal off the lens surface sticker.
MW
PIR
MW
PIR
LONG RANGE
(when using CL-80N)
(OML-ST only)
Wall
tamper
knockout
INSTALLATION INSTRUCTIONS
No.59-1484-0
HIGH-END INDOOR DETECTOR
OPTiMAL series
HIGH-END INDOOR DETECTOR
OPTiMAL series
OPTiMAL series provides a comprehensive product lineup from
standard to high-end model which suitable for any applications.
In addition to providing high reliable basic performance with our unique
infrared detection technology, the combination of active IR and dual
technology provides outstanding anti-masking reliability.
OPTiMAL series provides compliance with EN50131-1.
•OML-ST
: standard model with PIR
(Grade 2)
•OML-AM
: OML-ST with active IR anti-masking method (Grade 3)
•OML-DT
: standard model with PIR and microwave
(Grade 2)
•OML-DAM
: OML-DT with active IR anti-masking method (Grade 3)
IMPORTANT>>
- Set the DETECTION MODE switch “STD” position (see 6-B)
- Set the PIR SENSITIVITY “HIGH” with detection range over 20m (67ft.)
(see 6-H)
Caution to release the unit base>>
TOP VIEW
SIDE VIEW
TOP VIEW
SIDE VIEW
DETECTION AREA
3
KNOCKOUTS
2
INSTALLATION HINTS
1
Corner
mount
knockout
Mounting
knockout
Corner
mount
knockout
Wiring knockout
QUALITY ASSURANCE
Pull up the base
Pull out
When using a bracket>>
Choose the appropriate
mounting holes for corner or
wall fixing.
When using a wall tamper>>
Use the knockout for a wall
tamper. If the main unit if
prised off the wall, the grey
section will break away and
stay on the wall and the
tamper switch will operate.
When installing on a plaster
board wall or other soft
material, pre cut out the grey
area from the back plate.
note) Mount both knockouts
with accessory screws
