WIRELESS GATEWAY QUICK-START GUIDE | 2
STEP 3
•
Plug in the blue CAT5E Ethernet Patch Cable (included with
the Wireless Gateway)
.
Plug the Ethernet Cable into the ATM’s
Ethernet port inside the ATM, and to the OC-250 port labeled
“Ethernet” on the front of the Wireless Gateway.
As the unit boots, the “Cell On” and “Signal” lights will light and
turn solid. Once solid, proceed with pramming the ATM for
TCP/IP communication. See below for Nautilus Hysong ATMs,
page 4 for Hantle (Tranax) ATMs, or page 5 for Triton ATMs.
TCP/IP Requirements
NOTE:
The OC-250 runs only High-speed wireless TCP/IP transactions only possible
with ATMs capable of communicating via TCP/IP.
The OptConnect OC-250 runs high-speed transactions via TCP/IP
communication. TCP/IP communication significantly cuts transac-
tion speeds over dial-up transactions requiring less time for your cus-
tomer to complete their transaction.
Running TCP/IP involves programming the ATM for this specific mode
of communication. You must have master-password access to the
ATM programming menus to make the necessary changes.
TCP/IP Setup - Nautilus Hyosung ATMs
Nautilus Hyosung
ATMs capable of TCP/IP communications include:
1800CE, 2700CE, MM5000, MM5300CE, MM5100T
Once the physical installation is complete, enter the Operator Menu
of your ATM using the Master Password. If your ATM menus appear
differently than described below, please call OptConnect at (877)
678-3343 for further assistance.
