Oprema Juice Premix-Postmix, Installation & Service Booklet

Page: 28 / 36

<page nr>
EN
28
Buttons:
The buttons on the front panel control the water valves. You
can see 4 buttons, but you can just press one button
simultaneously.
DESRIPTION AND INSTALLATION
Cooling system:
The cooling system consists of an aluminum block coolant with built-in stainless steel
tubes.
Front panel:
The front panel in dimension 430x330 made of plexiglas and
is part of the doors. Under the front panel are dispensing
buttons. On the inner of the main door is placed door which
serve for commercial change, For opening unscrew latch on
inner door. Commercial foil is placed between fixed plexiglas
panel and white plastic panel. White plastic panel is placed
in side slots and additionaly fixed with magnets (6x)
Drip tray:
The drip tray is made of stainless steel and adaptable to the
heights of the glass.
Where the maximum permissible inclination is 2 degrees. When installing an air-cooled unit it
is necessary to ensure that the unit has enough of free space, which is 0.4 m in front of the
entrance and exit of the air. The unit should be placed on a flat and ventilated space away from
the heat source, at least 7 cm away from the wall and 30 cm from the next unit. It is necessary
to look around device to ensure free air circulation. Make sure the dispenser is vertical.
Adjustment is made with adjustable feet. Inside the cabinet you will find additional
equipment.
The device must be properly positioned on the surface:
Connect the water hose from the unit to the cold water supply. Let
water running and check for leaks. Do not forget to put a gasket on it.
Connect the mains plug to the wall socket. (Compressor starts with
cooling system and front panel lights up).