Opkon OP-CN4, User Manual, Page: 3 / 4

11. dSPtyP
This parameter defines screen format.Available 3 states;
• Press SET button to enter the submenu When stay on dSPtyP
•
Please refer to
"
enterring the CodE.
"
•
Press . UP/DOWN buttons and select one of this condition.
1. INC : Screen shows INCREMENTAL Value.
2. LEngtH : Screen shows MEASURING Value.
3. Both : By UP/DOWN buttons can be see INC/Measuring values.
•
Press SET button to save.
•
If u want to back menu without saving Press RST button (ESCAPE).
•
Then equipment backs to main menu automatically.
12. rECodE
This Parameter is used to Change the Password(COdE).If the new Password is written “000000” then
the Equipment do not ask any Password.
•
Press SET button to enter the submenu When stay on rECodE.
•
Please refer to
"
enterring the CodE.
"
•
Press UP/DOWN buttons to write new CodE.
• Press SET button to save.
•
If u want to back menu without saving Press RST button (ESCAPE).
•
Then equipment backs to main menu automatically.
13. dAtA
This parameter is used to HOLD or DELETE the last counter value in the Memory While the Equipment
is switched down electricaly.Available 2 states;
•
Press SET button to enter the submenu When stay on dAtA
•
Please refer to " enterring the CodE. "
•
Press . UP/DOWN buttons and select one of this condition.
1. rEC : Counter value is stored on memory.When power turns on, counting value comes to screen.
2. CLear : Counter value is not stored on memory.When power turns on counting value starts from
oFFSEt value.
• Press SET button to save.
•
If u want to back menu without saving Press RST button (ESCAPE).
•
Then equipment backs to main menu automatically.
14. FCtory
This Parameter helps to turn the factory settings.This parameter has a specific code.To turn the factory
settings;
•
Press SET button to enter the submenu When stay on FCtory
•
Press UP/DOWN buttons to write “352947” on display.
• Press SET button. trUe appears for 2 seconds.
•
At the end of the 2 second, rEStrE( ReStore) appears on the upper display ,and
dEFS (dEfaults) appears on the lower display.
•
Press SET to turn the factory settings.
• LodnG (loading) appears on the display for 3 second.The equipment turns the factory
settings end of the 3 seconds.
•
If u want to back menu without turning the factory settings Press RST button (ESCAPE).
•
Then equipment backs to main menu automatically.
15. SoFt
This parameter shows the version of the software.
ENTERING “CODE”
For Changing any Parameter, Stay on and Press SET button.Program will ask “CodE” to enter.
Entering the code is shown below;
•
ENTER CodE by UP/DOWN buttons
•
CodE is “ 000001 ” by factory settings.
• Pres SET button to enter the code.
•
If the code is correct,for 2 seconds .TrUE will be shown on display.
•
Then you do not need to re-enter code during programming.
•
For changing CodE please refer submenu Settings.(11-rECodE).