Opitec OPI-Robo R3O3, Manual, Page: 4 / 9

4
E111666#1
9
3
INSTRUCTIONS
8. Note:
Arrange the legs, so that the machine in thelarge gears,
which drive the legs, are set at 180 degrees. ( Dia 10)
Mount the motor and gearbox (3) with the two small
gears (14) on the front of the body with 4 screws (9) The
small gear must mesh with the larger gear (15) (Teeth
engage). When tightening the screws you should be
careful that it does not slip and that the larger gears are
still at 180 degrees. (s. Dia.11)
Once the gearbox is in place test the motor with a bat-
tery (3volt) Plus to the top motor contact .If all is correct
the legs will move one after the other (180 degrees )
and not catch aginst each other
9. Fix the battery holder (6) to the back
of the body (6) using 2 screws (9) (see
Dia 12.)
10. Fit the micro switch (7) in the mouth
with glue (s. Dia 13)
Dia.10
NOTE!
Should the legs not function properly, remove it from the power source immediately. Check over the mechanical function
manually once more.
Dia. 11
Dia. 12
Dia. 13
Dia. 14
11. Fit the two Light Emitting Diodes
(LEDs) (8) as eyes in the 5mm holes
in face, secure instant glue. Make
sure that the shorter legs (Catho-
de) ,on the LED side with flat, face
upwards. (s.Dia 14)
Cathode=short
Flattened edge side
Anode + = longer leg