7
D111172#1
INSTRUCTIONS
Bild 5.10
5.10. Cut a ca. 20-30 mm long piece from the remainder of the copper wire, remove the insu-
lation from the ends and bend it at 90 degrees in the middle. Fix it in the connector block
(s.step 5.9) Photo 5.10
5.11. Take a ca. 60mm long length and remove the insulation
from both ends and fix it to the connector block (11) Arrange
the reed contact (6) so that it exactly alongside the middle
of the coil and exactly in the middle of a magnet (7) te exact
positon can be adjusted with the connector block
( see Page 5.12)
5.11. Fix the last connector block on the base with a mchine
screw ( 14). (see Photo 5.11)
Finally connect the two connector blocks with the wire . (see
Photo 5.11 right)
Bild 5.12
6. Testing the function
6.1 Connect a 4,5 V Flat shaped battery to the wire ends ( Insulation remo-
ved ) and then spin the rotor
Should the motor not start up,adjust the position of the reed contact
and check all the connections
Bild 5.11
Summary of Contents for 111.172
Page 2: ...2 D111172 1 ...
Page 8: ...8 D111172 1 ...
