G400P User Manual
OpenVox Communication Co. LTD.
URL: www.openvox.cn
14
Chapter 3 Software Installation and Configuration
3.1 Hardware detection
Detect hardware by executing command:
# lspci –vvvv
Check the outcome and confirm your system has recognized G400P. If it
has been recognized, the outputs information will be showed like that:
03:00.0 Class ff00: Unknown device 1b74:0100 (rev 01)
Subsystem: Unknown device 1b74:0104
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 169
Region 0: Memory at febf0000 (32-bit, non-prefetchable) [size=64K]
Figure 6 Hardware detection
If G400P is not recognized by the system, you have to power off and take
out of the card, then try to insert it into another PCI slot.
3.2 Dependencies installation
Some dependencies are crucial, if any of them is absent, the software
installation process would not go through successfully. Let’s run
"
yum
install XX
"
(XX stands for the dependency’s name) to check the
availability of some dependencies.
