B100P on DAHDI User Manual
OpenVox Communication Co. LTD.
URL: www.openvox.cn
14
3.2 Installation
1
. Hardware detection
# lspci –vvvv
Check the outcome and confirm your system has recognized B100P. If it
has been recognized, "Network controller" will be displayed in the output
information like that:
02:0b.0 Network controller: Cologne Chip Designs GmbH ISDN network
controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Control: I/O- Mem+ Bu SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 16 (4000ns max)
Interrupt: pin A routed to IRQ 177
Region 0: I/O ports at dfe0 [disabled] [size=8]
Region 1: Memory at feafac00 (32-bit, non-prefetchable)
[size=256]
Capabilities: [40] Power Management version 1
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: vzaphfc
Kernel modules: zaphfc, hisax
Figure 4 Hardware detection
If B100P is not recognized by the system, you have to power off and take
out the card to insert it into another PCI slot.
