Opengear ADC-8434-A, User Manual

Page: 18 / 36

2–4 • Installation ADC-8434-A User Manual (Iss. 01)
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Installing the ADC-8434-A
Use the following procedure to install the ADC-8434-A in a DFR-8300 series frame:
1.
Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2.
Hold the ADC-8434-A by the edges and carefully align the card-edges with the slots in
the frame.
3.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4.
Verify whether your Rear Module Label is self-adhesive by checking the back for a thin
wax sheet. You must remove this wax sheet before affixing the label to the rear module
surface.
5.
Affix the supplied Rear Module Label to the BNC area of the Rear Module.