Opengear ADC-8434-A, User Manual

Page: 17 / 36

ADC-8434-A User Manual (Iss. 01) Installation • 2–3
Installing the ADC-8434-A
This section outlines how to install a Rear Module in a DFR-8300 series frame. The same
procedure applies regardless of the frame or card type. However, the specific Rear Module you
need to install depends on the frame you are using. Note that Slot 1 is the left most slot as you
look into the openGear frame from the front.
Rear Modules for the ADC-8434-A
The Rear Module for the ADC-8434-A depends on the openGear frame you are installing the
card into. The following rear modules are required:
• DFR-8310 series frame — When installing the ADC-8434-A in the DFR-8310 series
frames, the 8310AR-036 Rear Module (R1A-8434) is required. The ADC-8434-A is not
compatible with the DFR-8310-BNC frame.
• DFR-8321 series frame — When installing the ADC-8434-A in the DFR-8321 series
frame, the 8320AR-036 Full Rear Module (R2A-8434) is required.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “ Installing the ADC-8434-A ” on
page 2-4.
Use the following procedure to install a Rear Module in your DFR-8300 series frame:
1.
Locate the card frame slots on the rear of the frame.
2.
Remove the Blank Plate from the slot you have chosen for the ADC-8434-A installation.
If there is no Blank Plate installed, proceed to the next step.
3.
Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation in a DFR-8300 Series Frame (ADC-8434-A not shown)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
Screw Hole
Module Seating Slot