Opengear ADA-8402-A, User Manual

Page: 18 / 36

2–4 • Installation ADA-8402-A User Manual (Iss. 01)
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Installing the ADA-8402-A
Use the following procedure to install the ADA-8402-A in a DFR-8300 series frame:
1.
Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2.
Hold the ADA-8402-A by the edges and carefully align the card-edges with the slots in
the frame.
3.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4.
Verify whether your label is self-adhesive by checking the back of the label before
applying the label to the rear module surface.
5.
Affix the supplied Rear Module Label to the BNC area of the Rear Module.