Open Date Equipment EUROCODE 150, Operator Instructions Manual, Page: 18 / 33

Eurocode (Analogue) 26/04/05 Page 17
ELECTRONIC FAULT FINDING
FAULT POSSIBLE CAUSE
No lights when control unit is switched on. No power to control unit.
Fuse blown on PCB.
Control panel lights, including green, are
illuminated but printer will not operate
either by remote trigger signal or TEST
button. No air.
Fault on PCB.
Control panel lights, except green, are
illuminated and printer will not operate
either by remote trigger signal or TEST
button. Solenoid valve failure.
Solenoid valve disconnected.
PRINT switch off.
Alarm sounds continually. Type holder door open.
Foil magazine not fully engaged.
Safety microswitch failure.
Printer plug not properly mated.
No foil present (if foil alarm is fitted).
Foil not positioned over sensor (if fitted).
Foil sensor misaligned (if fitted).
Foil sensor failure (if fitted).
Printer does not heat, red L.E.D. is
illuminated. Heater failure.
Broken wire between heater and socket.
Fault on PCB.
Printer does not heat, yellow L.E.D. is
illuminated. In extreme cold conditions
press and hold down
TEST button for 5 -
10 seconds.
Plug/socket disconnected.
Thermistor failed open/short circuit.
Fault on PCB.
Heater fails to switch off, yellow L.E.D.
stays on. Fault on PCB.
Heater fails to switch off, red L.E.D. stays
on. Fault on PCB.
Thermistor probe loose in housing.