O p a l e - P a r a m o d e l s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
[email protected] +33(0)981 144 387
PO
WER 1.1
Repair
Repair a tear (if it don’t exceed 10cm)
Some adhesive tissue is provided with the wing at purchase.
Arm yourself with the good color, and cut an oblong shape pad with 2 cm outside outlines regarding to the
tear shape.
Position this pad on the wing’s extraback and be careful to not make any folds. Teared parts must be put edge
to edge.
Press firmly on the adhesive tissue in order to remove the air.
Replace a damaged bridle
Arm yourself with the raw material included with your wing. Natural color Aramid is 25 daN. It is used for the
bridle connected to the wing, on the clip.
Red Aramid is 50 daN, used to connect the 25 daN bridle and the risers link.
If a bridle is cut, it is important to use exactly the same material and redo as before the same length, to the
millimeter, by respecting the procedure below.
Use a needle to be papered, with a round endpoint and liquid cyanoacrylate glue.
To perform the first buckle, put a mark at 4 cm from the endpoint with a marker pen. Then, put 2 another marks
with 1cm space between each. Then place the endpoint in the needle’s hole.
Final length must be measured on each buckle endpoint.
7
