SAFETECH ST60-
X
SAFETECH ST60-
X
O p a l e - P a r a c h u t e s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
[email protected] +33(0)981 144 387
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
O p a l e - P a r a c h u t e s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
[email protected] +33(0)981 144 387
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
Assembling
Assembling
The arming rod has to stand out at the base of the
tube..
Lock the arming rod with the “Remove Before Flight”
pin.
Arrange the horn on the servomotor. Push it up on
the highest position. Then place the horn in the posi-
tion shown on the picture.
This position correspond to the Ejection status.
Check that the horn is able to reach this low position
during a move. The pin must be place on the second
hole of the arming rod.
This position correspond to the Locking status.
Arrange on top of the tube, a piece of adhesive foam
provided.
Do the same operation symetrically in relation to the
first piece of adhesive foam.
Parachute preparation and installation
Remove the parachute from its pocket and unfold it
totally.
Cut the line connecting the parachute to the con-
tainer.
A parachute properly stocked and aerated, without
being permanently held in a constant pressure allows
a faster and a more efficient deployment.
Make sure that the lines are not entangled.
Hold the lines with something heavy like a ballast or
anything at your disposal.
Arrange on both sides of the lines the parachute
panels.
Then place all the panels on one side.
Afterwards toggle them one by one on the other
side. This operation allows to properly place the fab-
rics for an optimal opening.
8
9
