the supervision of responsible adults;
- Children of less than 3 years should be kept away unless continuously supervised.
5) This appliance must only be used for the purpose for which it has been manufactured.
6) If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If the above is disregarded,
the safety of the appliance may be compromised.
7) Switch off the appliance and remove the plug from the electrical outlet when not in use.
8) The use of any electrical appliance calls for the awareness of some basic rules, such as:
- do not use the appliance near sources of water such as baths, showers or swimming pools
- do not touch the appliance with wet or damp hands or feet
- do not leave the appliance exposed to atmospheric agents
9) Do not use the appliance in the presence of potentially flammable or explosive liquids or gases.
10) Keep the suction grille clean.
3. INSTALLATION
FOOT ASSEMBLY
To assemble the two feet, position them in their housings and secure them with supplied ST4*10*3 screws. To move the
appliance, switch it off and disconnect it from the mains, then wait for it to cool down. Use the side gripping points for
transport.
WALL ASSEMBLY
Note: This product must be installed at least 15cm from the floor and 50cm from the ceiling.
Perform the operations below for wall mounting:
1) Make two holes 335mm apart with 8mm diameter and 40mm depth in the wall.
Note: Before drilling, make sure that there are no wires or other pipes located in the wall to prevent damage.
2) Insert the supplied anchors in the holes, then use a screwdriver to tighten in screws supplied with anchors, screws
must protrude 6mm from the anchor, finally, hang the product in the hook holes on the back.
