
Onyx.
Advanced car security solutions
16 Shapira St. Rishon Le - Zion 75052, Israel
Tel: 972-3-9413313 ; Fax: 972-3-9413330
www.onyxtech.co.il ; [email protected]
Page 11 of 12 EGPRS Unit User Guide
3
Installation Guide
3.1
EGPRS Vehicle Installation
1. Make sure a SIM card is inserted into the unit.
2. Connect the black wire to a permanent GND.
3. Connect the red wire to a permanent 12V or 24V source through a 3A fuse.
Note: Suitable approved slow-blow fuse 3A should be provided by the End
User.
4. When applicable, connect the brown wire of the I/O harness to the Ignition switch
(ignition on should supply 12/24V to the brown wire).
5. Connect the GPS connector to the unit if a GPS is installed.
Figure 5 - Up View
3.1.1
Attention:
The EGPRS unit must not be installed next to heat sources or moving parts.
The installation position must be water proof.
The EGPRS unit should be installed in the cabin or the trunk.
The EGPRS unit should not be installed behind the fuse box.
The antenna side of the EGPRS unit should be facing upwards if possible,
Never install the EGPRS unit with the antenna side next to metal.
The EGPRS must be installed by qualified service personnel only.
3.1.2
SIM Card
Insert the SIM card as shown in the following picture:
Figure 6 - SIM Card insertion