10
11
12
Snap both fillers
[P]
into the curb and header
between the hinge and strike jambs with the raised
lips
on the exterior side. Center the curb filler between the
hinge and strike jamb (use masking tape to hold in
position).
NOTE: The snap-in fillers should be exactly 7/16"
longer than the door panel width.
Press the bottom end of the hinge jamb
[L]
tightly
against the curb filler
[P]
and plumb the jamb. Drill two
1/8” holes thru the hinge jamb and into the 135 ° post
1/2" from the outside long edge, and approximately
1/4" from each short edge of the jamb. Drill a third hole
centered between the first two and enlarge the outer
holes with a 3/16" drill for clearance on the self-tapping
screws. Attach the hinge jamb to its post with three #6 x
3/ 8" self tapping screws
[C]
.
Press the header filler tightly against the hinge jamb.
Push the strike jamb
[N]
tightly against the top and
bottom
. With the hinge jamb
plumb and both
fillers
tight between the two door jambs, the strike
jamb also will be plumb and parallel to the hinge jamb.
Attach the strike jamb to its post with three screws in the
same manner as you did the hinge jamb.
[K]
fillers
[L]
[P]
Slide the door pull handle
[CC]
with magnet onto
the strike edge of the door panel. Close the door and
slide the handle up or down until the two magnetic
are aligned. Use a pencil or masking tape to mark the
location of the handle
on the door.
Slip the door handle vinyl
[DD]
onto the door be tween
the marks and careful ly tap the door handle onto the door
panel using a rubber mallet. Spraying glass cleaner
or water onto the vinyl will make assembly easier.
Close the door and check for proper operation of the
magnetic catch.
P
P
C
N
CC
#6 x 3/8" SCREWS
(6 pcs)
HINGE
JAMB
STRIKE
JAMB
L
OM
1/2" FR
E
DGEOF
JA
STRIKE
MB
DOOR
PANEL
1/
OM
2"F R
E
E OF
DG
I G EJA
H N
MB
4"
1/
4"
1/
o
135
POST
o
135
POST
HEADER
FILLER
CURB
FILLER
P
K
K
P
P
HINGE
JAMB
1/8”
Page 6 of 8
