AUTO HEADING ADJUST
Auto heading adjusting !
Please keep constant speed less
than 2 minutes for each turn
Cancel [ESC] OK [ENT]
1.5.2 Auto Heading Adjust
In the menu select
and press
[ENT]
key.
The following window appears:
The compass has been calibrated during manufacture. This calibration will be
satisfactory for almost all installations. If you have a steel vessel, or some
other factor which causes the compass to perform poorly, the calibration
procedure will adjust compass characteristics to compensate.
The calibration should only be done if the compass is known
to be inaccurate.
If the KEC-30 display as constant offset
(e.g. the compass reads 3 degrees
high on all bearings), simply rotate the Fluxgate Sensor case to align
bearings with the ships compass. It is not necessary
to re-calibrate the
compass as described below.
If the KEC-30 has inconsistent variation on different headings, the following
calibration procedure can be carried out. This procedure should only be done
in calm waters with adequate sea room.
"
AUTO HEADING ADJUST
"
10
